A production-ready Power Mesh Knit for Training Shorts, specified around abrasion resistance plus a comfortable liner. Composition is nylon spandex with copper bearing filament, which delivers antibacterial action plus faster heat transfer away from the skin. Every lot is finished and tested so that Quick-Dry is measurable rather than claimed.
Nylon Spandex Copper Ion Filament 150 GSM Power Mesh Knit, face view
Key specifications
| Parameter | Value |
|---|---|
| Fabric name | Nylon Spandex Copper Ion Filament Quick-Dry Power Mesh Knit |
| Composition | nylon spandex with copper bearing filament |
| Construction | Power Mesh Knit (a high modulus warp knit mesh) |
| Weight | 150 GSM |
| Width | 155 cm |
| Function | Quick-Dry — releases absorbed moisture fast enough to be ready for the next session |
| Performance target | residual moisture below 15% after 30 minutes |
| Test method | AATCC 199 drying rate |
| Additional value | drying time roughly half that of a cotton equivalent |
| Stretch | Four-way, recovery above 92% |
| Certification | OEKO-TEX Standard 100, REACH compliant inputs |
| MOQ | 300 m per colour |
| Lead time | 20–25 days after approval |
Why this construction works
The construction does the work before any chemistry is added. a high modulus warp knit mesh means controlled support at very low weight with maximum air exchange, and that structure is what allows the fabric to releases absorbed moisture fast enough to be ready for the next session under the conditions Training Shorts actually face.
Power Mesh Knit construction shown at close range
Performance features
- Quick-Dry: releases absorbed moisture fast enough to be ready for the next session, measured by AATCC 199 drying rate.
- Hand and comfort: antibacterial action plus faster heat transfer away from the skin.
- Construction benefit: controlled support at very low weight with maximum air exchange.
- Consistency: GSM and width tolerance are locked per lot and recorded on the inspection sheet.
- Durability: performance is verified after repeated washing, not only as delivered.
Recommended applications
The first choice for Training Shorts, where abrasion resistance plus a comfortable liner is the requirement that decides the fabric. It also converts cleanly into coordinated pieces in the same programme, since the hand and the shade run together.
Quick-Dry fabric prepared for Training Shorts production
Dyeing, finishing and customisation
Available in piece dyed, yarn dyed or sublimation ready form. Functional finishes such as moisture management, antibacterial, anti-pilling and UV absorption can be applied individually or combined, and each is verified against its test method before bulk release.
Care instructions
- Machine wash at 30 degrees with mild detergent, no fabric softener.
- Dry away from direct heat and do not tumble dry hot.
- Cool iron on the reverse if needed, and avoid bleach.
Ordering, sampling and quality control
Trial quantity starts at 300 metres per colour with laboratory dips in five working days. Bulk lead time is 20-25 days after approval, and every lot ships with a test report, a shade check and an inspection record.
Roll inspection and packing before shipment
Frequently asked questions
Is the performance tested on every lot? Yes. The named test method is repeated on bulk fabric, not only on the approval sample, and the report carries the lot number so results can be traced back.
Can we get recycled content with this construction? In most cases yes. GRS certified recycled nylon or polyester can replace the virgin yarn with full chain of custody documents, usually with no visible change in hand or performance.
