75% Nylon 25% Spandex Quick-Dry Power Mesh Knit combines 75% nylon 6 filament / 25% spandex with a Power Mesh Knit construction. It is aimed at Training Shorts that require abrasion resistance plus a comfortable liner, and the reason is straightforward: higher power for compression grades that still run on standard knitting machines, so Quick-Dry.
75% Nylon 25% Spandex 130 GSM Power Mesh Knit, face view
Key specifications
| Parameter | Value |
|---|---|
| Fabric name | 75% Nylon 25% Spandex Quick-Dry Power Mesh Knit |
| Composition | 75% nylon 6 filament / 25% spandex |
| Construction | Power Mesh Knit (a high modulus warp knit mesh) |
| Weight | 130 GSM |
| Width | 175 cm |
| Function | Quick-Dry — releases absorbed moisture fast enough to be ready for the next session |
| Performance target | residual moisture below 15% after 30 minutes |
| Test method | AATCC 199 drying rate |
| Additional value | drying time roughly half that of a cotton equivalent |
| Stretch | Four-way, recovery above 92% |
| Certification | OEKO-TEX Standard 100, REACH compliant inputs |
| MOQ | 300 m per colour |
| Lead time | 20–25 days after approval |
Why this construction works
The construction does the work before any chemistry is added. a high modulus warp knit mesh means controlled support at very low weight with maximum air exchange, and that structure is what allows the fabric to releases absorbed moisture fast enough to be ready for the next session under the conditions Training Shorts actually face.
Power Mesh Knit construction shown at close range
Performance features
- Quick-Dry: releases absorbed moisture fast enough to be ready for the next session, measured by AATCC 199 drying rate.
- Hand and comfort: higher power for compression grades that still run on standard knitting machines.
- Construction benefit: controlled support at very low weight with maximum air exchange.
- Consistency: GSM and width tolerance are locked per lot and recorded on the inspection sheet.
- Durability: performance is verified after repeated washing, not only as delivered.
Recommended applications
The first choice for Training Shorts, where abrasion resistance plus a comfortable liner is the requirement that decides the fabric. It also converts cleanly into coordinated pieces in the same programme, since the hand and the shade run together.
Quick-Dry fabric prepared for Training Shorts production
Dyeing, finishing and customisation
Available in piece dyed, yarn dyed or sublimation ready form. Functional finishes such as moisture management, antibacterial, anti-pilling and UV absorption can be applied individually or combined, and each is verified against its test method before bulk release.
Care instructions
- Machine wash at 30 degrees with mild detergent, no fabric softener.
- Dry away from direct heat and do not tumble dry hot.
- Cool iron on the reverse if needed, and avoid bleach.
Ordering, sampling and quality control
Trial quantity starts at 300 metres per colour with laboratory dips in five working days. Bulk lead time is 20-25 days after approval, and every lot ships with a test report, a shade check and an inspection record.
Roll inspection and packing before shipment
Frequently asked questions
Is the performance tested on every lot? Yes. The named test method is repeated on bulk fabric, not only on the approval sample, and the report carries the lot number so results can be traced back.
What is the minimum for a first order? Development starts at 300 metres per colour, which is enough for a proper wear trial and a small capsule. Bulk pricing improves at 1,000 metres and above per colour.
