Visible Sweat Marks Solutions for Swimwear: Comparison of Options
Three working routes exist for visible sweat marks in swimwear. This page compares them by performance, cost and risk.
Option A: change the yarn
Changing fibre composition usually gives the largest improvement. It costs more and needs a new minimum quantity, but absorbency under 1 second on the inner face is easier to hold over time. Because the fabric stays wet, stretched and chemically exposed for hours, target checks are made on a worn sample rather than flat fabric alone.
Option B: change the structure
Adjusting knit density is cheaper and faster. The trade-off is a narrower operating window, so process control becomes more important. Keep AATCC 79 absorbency named in the tech pack so every lot is measured the same way.
Option C: change the finish
Finishing delivers fast results and can be added late. The risk is wash durability, so check performance after 10 and 20 washes. Where swimwear is worn for pool training and beach use, set tolerances around that range of movement.
Cost comparison
Indicative cost impact: dual-face finishing adds about 4 cents. Testing adds little, while the cost of a rejected shipment is far higher. Any change to nylon and polyester knits at 190-230 GSM with high elastane requires re-testing against absorbency under 1 second on the inner face before bulk is released.
Recommended route
For pool training and beach use the practical route is normally build a hydrophilic inner face and hydrophobic outer face combined with use melange or printed colourways. Confirm with AATCC 79 absorbency before releasing bulk. Past reports from AATCC 79 absorbency help the mill reproduce the same recipe on the next order.
