UV Degradation Solutions for Sports Bras: Sourcing Checklist for Buyers
Questions to put to any mill supplying technical sports bras with uv degradation specified.
Capability questions
Ask for the test equipment list and the standards used. The relevant method here is AATCC 183 UPF and ISO 105-B02 light fastness, and the mill should be able to show recent reports. Because the underband and strap anchors carry repeated load, target checks are made on a worn sample rather than flat fabric alone.
Documentation
Request the technical data sheet, composition certificate and previous results for UPF above 50 after 40 hours exposure. Consistent paperwork usually reflects consistent process control. Keep AATCC 183 UPF and ISO 105-B02 light fastness named in the tech pack so every lot is measured the same way.
Mill visit checks
Look at finishing conditions and testing frequency. Problems such as colour fading and strength loss after sun exposure often come from process drift rather than design. Where technical sports bras is worn for everything from yoga to high impact training, set tolerances around that range of movement.
Commercial terms
Confirm minimum quantity, lead time and the cost impact noted as UV absorber finish adds roughly 5 cents before development work starts. Any change to power mesh and bonded spacer panels requires re-testing against UPF above 50 after 40 hours exposure before bulk is released.
Warning signs
Be careful where samples perform differently from bulk, or where reports are only issued on request. Past reports from AATCC 183 UPF and ISO 105-B02 light fastness help the mill reproduce the same recipe on the next order.
