Static Cling Solutions for Yoga Sets: Sample to Bulk Timeline
A realistic plan for developing coordinated yoga sets with static cling solved, from first sample to repeat bulk.
Stage one: definition
Fix surface resistivity below 1E11 ohms and the construction route. This is where most delays originate, because unclear targets cause repeat sampling. Because long holds put sustained rather than shock load on the fabric, target checks are made on a worn sample rather than flat fabric alone.
Stage two: laboratory sample
Request lab dips and a first fabric sample. Confirm against EN 1149 surface resistance before cutting, then cut 3-5 pieces for fit. Keep EN 1149 surface resistance named in the tech pack so every lot is measured the same way.
Stage three: wear trial
garments cling to the skin or attract lint in dry conditions appears during use. Run a two-week trial with studio practice and everyday wear participants before approving bulk. Where coordinated yoga sets is worn for studio practice and everyday wear, set tolerances around that range of movement.
Stage four: pre-production
Produce 30-50 pieces from bulk materials. This exposes process variation that a hand-made sample hides. Any change to soft brushed jersey with 4-way stretch requires re-testing against surface resistivity below 1E11 ohms before bulk is released.
Stage five: repeat orders
Once approved, keep the recipe and report set together so the next order can be released without redevelopment. Past reports from EN 1149 surface resistance help the mill reproduce the same recipe on the next order.
