Compression Decay Solutions for Sports Bras: Specification Checklist
Use this checklist to write compression decay requirements for technical sports bras into a tech pack that a mill can quote against.
Targets to fix before sampling
Write above 90% elastic recovery after 20000 cycles into the pack. Mills quote against the number on the page, so vague language leads to variable results. Because the underband and strap anchors carry repeated load, target checks are made on a worn sample rather than flat fabric alone.
Fabric construction
State structure, composition and finish together. Typical options for this build are power mesh and bonded spacer panels, adjusted to the performance level required. Keep ISO 13934-1 tensile with cyclic extension named in the tech pack so every lot is measured the same way.
Seam and trim requirements
The problem shows as the garment loses its support value over the wearing life. Construction choices either remove the cause or hide it for a few washes, so specify the method instead of the outcome. Where technical sports bras is worn for everything from yoga to high impact training, set tolerances around that range of movement.
Laboratory to request
Ask for ISO 13934-1 tensile with cyclic extension on every shade and every size run, not only the approval sample. Any change to power mesh and bonded spacer panels requires re-testing against above 90% elastic recovery after 20000 cycles before bulk is released.
Acceptance criteria
Agree the limit before sampling starts. Re-testing after disagreement costs more than setting the target clearly at the beginning. Past reports from ISO 13934-1 tensile with cyclic extension help the mill reproduce the same recipe on the next order.
