Odour Retention Solutions for Running Shorts: Comparison of Options
Three working routes exist for odour retention in running shorts. This page compares them by performance, cost and risk.
Option A: change the yarn
Changing fibre composition usually gives the largest improvement. It costs more and needs a new minimum quantity, but reduction of 99% against Staphylococcus aureus after 10 washes is easier to hold over time. Because high cadence movement plus perspiration at the waistband, target checks are made on a worn sample rather than flat fabric alone.
Option B: change the structure
Adjusting knit density is cheaper and faster. The trade-off is a narrower operating window, so process control becomes more important. Keep ISO 20743 and AATCC 100 named in the tech pack so every lot is measured the same way.
Option C: change the finish
Finishing delivers fast results and can be added late. The risk is wash durability, so check performance after 10 and 20 washes. Where running shorts is worn for road, trail and track training, set tolerances around that range of movement.
Cost comparison
Indicative cost impact: finish adds roughly USD 0.35-0.60 per garment. Testing adds little, while the cost of a rejected shipment is far higher. Any change to lightweight woven or knit body with a knit liner requires re-testing against reduction of 99% against Staphylococcus aureus after 10 washes before bulk is released.
Recommended route
For road, trail and track training the practical route is normally zinc-based or silver-ion antibacterial finish combined with increase scouring efficiency before dyeing. Confirm with ISO 20743 and AATCC 100 before releasing bulk. Past reports from ISO 20743 and AATCC 100 help the mill reproduce the same recipe on the next order.
