Squat-Proof Coverage Solutions for Swimwear: A Technical Guide
This guide sets out how squat-proof coverage can be engineered into swimwear before bulk production begins.
How the problem appears in production
knitted fabric loses opacity when it stretches over the body is most obvious the fabric stays wet, stretched and chemically exposed for hours. Buyers usually find it during fitting rather than in the lab, so early target setting matters. Because the fabric stays wet, stretched and chemically exposed for hours, target checks are made on a worn sample rather than flat fabric alone.
Specification targets that work
Set the measurable target at opacity above 96% at 30% extension. Without a number on the tech pack the mill chooses its own standard, which rarely matches the brand requirement. Keep AATCC 183 transmission with photography under 60% extension named in the tech pack so every lot is measured the same way.
Fabric and finish options
The practical route combines raise course density to 34-40 courses/cm, move to a dull filament or add a third yarn feed and add a light brushed finish to scatter transmitted light. Options can be combined, but every added step needs extra approval time. Where swimwear is worn for pool training and beach use, set tolerances around that range of movement.
Construction details
Pattern and seam placement decide whether the fix survives wear. Because the swimwear is used for pool training and beach use, allow for worst-case load rather than average use. Any change to nylon and polyester knits at 190-230 GSM with high elastane requires re-testing against opacity above 96% at 30% extension before bulk is released.
Validation before bulk
Approve against AATCC 183 transmission with photography under 60% extension and keep reports with the bulk file. A short pre-production run of 30-50 pieces exposes problems a lab sample cannot. Past reports from AATCC 183 transmission with photography under 60% extension help the mill reproduce the same recipe on the next order.
