Moisture Management (MMT) Setting It Correctly on a Tech Pack
Moisture Management (MMT) should be written into the tech pack with a value, a tolerance and a method. This removes ambiguity from quotations.
Definition to agree
ability to move liquid through the fabric. Working figures for Moisture Management (MMT) normally sit around class 3 to 5 for training wear in mainstream production. Note AATCC 195 moisture management tester on the tech pack so nobody tests against an older revision.
Target value
Open the specification at class 3 to 5 for training wear, adjusted to the end use. Record elastane content alongside Moisture Management (MMT), because blends shift the measured value. A result outside class 3 to 5 for training wear usually points to process drift rather than to the fibre itself.
Method line
Always pair the target with AATCC 195 moisture management tester so the mill and the laboratory test the same way. Keeping reference values for Moisture Management (MMT) lets suppliers quote without extra sampling rounds. Ask for conditioning details together with AATCC 195 moisture management tester, since both affect the reading.
Tolerance line
State plus or minus limits to keep production realistic while protecting the requirement. Working figures for Moisture Management (MMT) normally sit around class 3 to 5 for training wear in mainstream production. Note AATCC 195 moisture management tester on the tech pack so nobody tests against an older revision.
Approval step
Approve the result on pre-production bulk rather than on development fabric only. Record elastane content alongside Moisture Management (MMT), because blends shift the measured value. A result outside class 3 to 5 for training wear usually points to process drift rather than to the fibre itself.
