Meridian Form Norway: Industrial Workwear and Uniforms Durability and Abrasion Evaluation
Meridian Form is a Norway-based brand whose industrial workwear and uniforms is one of its most demanding programmes. Abrasion is the most common reason a technical garment is retired. We evaluated the bonded softshell knit against the contact surfaces found in industrial workwear and uniforms.
Meridian Form: Bonded Softshell Knit in use during long shifts in active physical roles
Evaluation background
The programme covers work shirts, trousers and fleece layers, used for long shifts in active physical roles. The environment is abrasive surfaces and industrial washing at high temperature and the requirement written into the brief was durability with easy care across a large size range. Fabric was selected on that basis rather than on price alone.
Fabric under evaluation
| Parameter | Value |
|---|---|
| Fabric | Bonded Softshell Knit |
| Composition | polyester face bonded to a TPU membrane |
| Weight | 300 GSM |
| Width | 160 cm |
| Primary function | blocks wind while still allowing vapour to escape |
| Target | water vapour resistance below 6 m2Pa/W |
| Test method | ISO 11092 |
| Additional note | bond strength above 15 N after washing |
| Certification | OEKO-TEX Standard 100 |
Bonded Softshell Knit close-up showing the fabric surface
Method
Fabric was abraded to ASTM D4966 against both a standard wool abradant and the actual contact surface used in long shifts in active physical roles. Seam strength was tested to ISO 13936-2 in parallel.
Results
The fabric passed the agreed cycle count with no yarn breakage and seam opening stayed inside the 6 mm limit. Pilling remained at grade 4 or above at the end of the test.
Evaluation session with the Meridian Form team
Where wear appeared
Any surface change appeared first under abrasive surfaces and industrial washing at high temperature, which is expected and is why we recommend panel placement rather than a single fabric across the whole garment.
Service life estimate
On this data the garment should complete a full competitive season before appearance becomes a reason to replace it, which is the commercial target Meridian Form set at the start.
Test records and inspection notes for the Industrial Workwear and Uniforms
Scorecard
| Criterion | Result |
|---|---|
| Abrasion cycles | 4.8 / 5 |
| Pilling grade | 4.6 / 5 |
| Seam strength | 4.5 / 5 |
| Appearance | 4.7 / 5 |
| Estimated service life | 4.4 / 5 |
“The report gave us numbers we could put in front of our retail partners without any argument.” — Meridian Form Technical Team
Packed bulk rolls before shipment to Norway
Verdict and recommendation
Durability is sufficient for the intended use. Keep the current construction and revisit only if the garment moves into a higher abrasion category. For Meridian Form the practical next steps are to keep the current specification for the repeat, retain the shade standard, and issue ISO 11092 results with every lot so any claim can be supported with data.
